Fujitsu ETERNUS DX100 S3 - Figure 1.11 FC Interface (Installed in a Controller); Figure 1.12 Host Interface for FC Cable Connection (Installed in a Controller)

● FC (for the ETERNUS DX100 S4)
The ports on the host interface are used for connecting a controller to a server with an FC cable. This port
uses a Dual LC connector.
Figure 1.11 FC Interface (Installed in a Controller)
4
5
6
1
2
3
1. Host interface (CA#0)
2. Host interface port (CA#0, Port#0)
3. Host interface port (CA#0, Port#1)
4. Host interface (CA#1)
5. Host interface port (CA#1, Port#0)
6. Host interface port (CA#1, Port#1)
● FC (for the ETERNUS DX100 S4 single controller model and the ETERNUS DX200 S4)
The ports on the host interface are used for connecting a controller to a server with an FC cable. This port
uses a Dual LC connector.
Figure 1.12 Host Interface for FC Cable Connection (Installed in a Controller)
1
2
3
4
5
6
1.
Host interface (CA#0)
2. Host interface port (CA#0, Port#0)
3. Host interface port (CA#0, Port#1)
4. Host interface (CA#1)
5. Host interface port (CA#1, Port#0)
6. Host interface port (CA#1, Port#1)
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
23
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0