13. LINK/FAULT LED
14. LAN ACT LED
15. LAN LINK LED
The LEDs turn on or blink to indicate the statuses that are listed below.
Table 1.3 Status and Meanings of Each LED (Controller)
LED name LED status Meaning
IDENTIFY/BBU FAULT
(blinks blue)
As ordered via ETERNUS Web GUI or ETERNUS CLI, the installation
location of the controller is identified.
(amber)
The battery is in error status.
DI (OUT) LINK/FAULT
(green)
The link between the DI (OUT) port and the destination port has
been established.
(amber)
•
The link between the DI (OUT) port and the destination port is
in error status.
•
The ports to remove the cables between enclosures from are in-
dicated. This occurs while a drive enclosure is being added.
(blinks amber)
The ports to connect the cables are indicated. This occurs while a
drive enclosure is being added.
READY/FAULT
(green)
The controller is in normal status.
(blinks green)
An error has occurred during startup.
(amber)
•
The controller is performing the initial setup after the power is
turned on.
•
The controller is in error status.
(blinks amber)
MASTER
(green)
The controller is set as a Master CM.
CA FAULT
(amber)
The host interface is in error status.
LINK/FAULT
(green)
The link between the host interface port and the destination port
has been established.
(amber)
The host interface port is in error status.
LAN ACT
(blinks green)
Data is being sent or received via the LAN port.
LAN LINK
(green)
The link between the LAN port and the destination has been es-
tablished.
■
Host Interfaces
A host interface is a board that has interface ports to connect a controller to the server.
There are seven types of host interfaces: FC 16Gbit/s, FC 8Gbit/s, iSCSI 10Gbit/s, iSCSI 1Gbit/s, SAS 12Gbit/s,
Ethernet 10Gbit/s, and Ethernet 1Gbit/s.
Chapter 1
Component Names and LED Names
1.1 Controller Enclosures
22
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
