Figure 1.10 Controller (ETERNUS DX100 S4/DX200 S4)
•
Pattern 1
12
12 10
6
5
14
15
14
15
13 13
81313
9
7
11
34
•
Pattern 2
1
56
14 15
14 1513 13 13 13
9
23
10 11 12
4
78
1.
PWC port
This port is used to connect a power synchronization unit with an RS232C cable.
2. DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a mini SAS HD cable between
enclosures.
3. RMT (LAN) port
This port is used for connecting a LAN cable and used for the remote support function. This port uses an
RJ-45 connector.
4. MNT (LAN) port
This port is used for connecting a LAN cable and used for operation management. This port uses an RJ-45
connector.
5. Host interface (CA#0)
Install host interfaces. For details, refer to "■ Host Interfaces" (page 29).
6. Host interface (CA#1)
Install host interfaces. For details, refer to "■ Host Interfaces" (page 29).
7. IDENTIFY/BBU FAULT LED
8. CA#0 FAULT LED
9. DI (OUT) LINK/FAULT LED
10. READY/FAULT LED
11. CA#1 FAULT LED
12. MASTER LED
Chapter 1 Component Names and LED Names
1.1 Controller Enclosures
21
FUJITSU Storage ETERNUS DX100 S4/DX200 S4, ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Operation Guide (Basic)
Copyright 2017 FUJITSU LIMITED
P3AM-7662-09ENZ0
To Next Page
Loading...
