Fujitsu FI-6010N - Using the Network Settings Menus; Giving the Scanner an IP Address

82
4.7 Using the Network Settings Menus
4.7.1 Giving the Scanner an IP Address
An IP address must be set in order to connect the scanner to a network.
1. Select the [Network Settings] tab on the top menu.
2. Select the [IP Address] tab on the left side menu.
 The DHCP or IP address setting screen appears.
3. Select whether or not a DHCP is required.
Set the scanner's IP address. This may be done automatically, by pressing the DHCP [On]
button. By default, this is set as [On].
The IP address may also be set manually, by pressing the DHCP [Off] button and entering
the following numerical addresses:
z IP Address
z Subnet Mask
z Default Gateway