170
■ Resetting Factory Defaults
1. Select the [Maintenance] tab on the top menu.
2. Select the [System Settings File] tab on the left side menu.
The "System Settings File" screen appears.
3. Press the [Reset] button.
A confirmation message appears.
4. Press the [Yes] button.
System settings revert to factory defaults.
After factory default settings have been restored, the scanner is restarted.
During factory defaults reset, do not press and hold down the startup
button for longer than 4 seconds, as it may cause the scanner to func-
tion abnormally.
After the factory default settings are restored, the scanner name, IP
address, and other settings will need to be set again, as described in "4.6
Using the System Settings Menus" (page 55).
To Next Page
Loading...
