fi-6010N Network Scanner Operator's Guide 579
E
■ Error
Code Message Action
7B020001 Scanner registration by Central Admin
server failed.
z For Central Admin Server
Check that the scanner is
registered on the Central Admin
Console "Scanner List" screen.
z For Scanner
Enter the address of the Central
Admin Server on the "Ping"
screen on the [Network
Settings] tab, and check
whether or not there is a
response from the Central
Admin Server.
If there is no response from the
Central Admin Server, check
whether or not DHCP is enabled
on the "IP Address" screen on
the [Network Settings] tab.
If DHCP is disabled, check that
the IP Address, Subnet Mask,
Default Gateway settings are
correct.
Check also that the network
between the scanner and the
Central Admin Server is
connected correctly.
Also check that the scanner's
server-side status is
"Registered" on the "Central
Admin Server" screen on the
[Network Settings] tab.
If the scanner's server-side
status is "Unregistered", check
the address and the port number
of the Central Admin Server,
and register the scanner on the
Central Admin Server.
To Next Page
Loading...
