fi-6010N Network Scanner Operator's Guide 469
A
A.2 Paper Requirements
A.2.1 Paper Type
The following paper types are recommended for use with the ADF:
z Woodfree paper
z Wood containing paper
When documents of a paper type other than those listed above are used, test-scan a few sheets first
to check if the document can be scanned without problem.
A.2.2 Paper Weight
The following paper weights can be used with the ADF:
z For general scanning
z 52 to 127 g/m
2
(14 to 34 lb)
z For A8 and Business Card size, 127 g/m
2
only
z For scanning with a Carrier Sheet
z Up to 127 g/m
2
(Up to 34 lb)
z Up to 63.5 g/m
2
(Up to 17 lb) (when scanning half fold paper)
A.2.3 Precautions
The following documents may not scan successfully:
z Documents of non-uniform thickness (e.g. envelopes and documents with attachments)
z Wrinkled or curled documents (See the following HINT)
z Folded or torn documents
z Documents with appended photographs, notes, etc.
z Tracing paper
z Coated paper
z Carbon paper
z Carbonless paper
z Photosensitive paper
z Perforated or punched documents
z Documents that are not square or rectangular
z Exceptionally thin documents (less than 52 g/m
2
)
z Photographs
Do not attempt to scan the following types of documents:
z Paper-clipped or stapled documents
z Documents on which the ink is still wet
z Documents smaller than A8 Portrait
z Documents wider than Letter size (8.5inches = 216mm, A4 is 210mm wide)
z Non-paper documents (such as fabric, foil, transparent paper)
To Next Page
Loading...
