4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 115
4
4.7.13 Setting the Network Printers
Set a printer connected to the network.
The procedure for setting a network printer is as follows.
1. Check the printer driver.
For more details, refer to "Checking the Printer Drivers" (page 116).
2. Set the printer properties.
For more details, refer to "Setting the Printer Properties" (page 117).
3. Register the network printer.
Up to 100 network printers can be registered.
A network printer can be registered in one of the following ways.
z Network Tree
Select a network printer from the network tree.
For more details, refer to "Registering a Network Printer (Network Tree)" (page 120).
z Network Path
Directly enter the network printer path name.
For more details, refer to "Registering a Network Printer (Network Path)" (page 123).
z Be sure to read the printer manual beforehand for information about
setting a printer, adding a network printer, and other cautions.
z If the drive on which the spool folder for the print server exists does not
have enough free space, printing will stop. Make sure that there is enough
space in the drive before printing.
z Do not set a virtual printer.
z If a printer connected to different print servers is to be registered as a net-
work printer multiple times, the software version of the driver should be the
same on each print server. If the software version of the printer driver dif-
fers, printing errors may occur.
To Next Page
Loading...
