Fujitsu FI-6010N - Page 131

4.7 Using the Network Settings Menus
fi-6010N Network Scanner Operator's Guide 95
4
2 Enter a port number for the proxy server, from 1 to 65535, in the "Port Number"
field.
Select [Off] to enable direct FTP connection (not via a proxy server).
4. Use the "SharePoint Proxy Server" option to set whether or not a proxy server is used
for SharePoint server connection.
The default setting is [Off].
Select [On] to enable SharePoint connection via a proxy server.
1 Enter the Central Admin Server IP address, host name, or FQDN in the "Address"
input field.
z For an IP address
The following format should be used xxx.xxx.xxx.xxx (xxx is a value from
0 to 255).
z For a host name or FQDN
Up to 255 characters may be entered.
2 Enter a port number from 1 to 65535, to be used by the scanner to communicate
with the Central Admin Server.
3 Any IP addresses, host names, or FQDN names that are to accessed directly (not
via the proxy server) should be entered in the "Exceptions" field.
z Multiple addresses must be separated using semi-colons (";").
z "*" may be used as a wildcard character.
z An IP address may be followed by a "/" and then a subnet mask.
Select [Off] to enable direct SharePoint connection (not via a proxy server).
5. Press the [OK] button.
 The proxy server is set.
ATTENTION
This "FTP Proxy Server" setting must be set to [On] if the "Proxy" setting for
any FTP server network folder is set to [On], or the FTP server network
folder will not be accessible.
For details of how to set an FTP server folder as a proxied network folder,
refer to "4.7.14 Setting the Network Folders" (page 128).