354
4. Set the properties, and press the [OK] button.
The "Scan to SharePoint" screen is shown again.
8. Select if existing files with the same name are to be overwritten.
The default setting is [No].
If a file name already exists, the existing file will not be overwritten and the scanned data
will be lost. Whether or not the file was successfully saved can be checked in the user log.
For more details about accessing the user log, refer to "6.12 Checking the User Log" (page
401).
9. Press the [Scan] button.
When [Scan Viewer] is Off, this will be a [Scan&Save] button.
Scanning starts.
Each page is briefly shown on the screen as it is scanned.
The maximum number of pages that can be scanned is 999.
When [Blank Page Skip] is enabled, the number of scanned pages excluding skipped
blank pages is shown.
Additional pages can be scanned in place of skipped blank pages, until the maximum
number of scanned pages is reached.
When the scan has completed, the "Scan Viewer" screen opens.
For more details about the "Scan Viewer" screen, refer to "6.11 Editing the Scanned Data
in the Scan Viewer" (page 396).
z [Scan Viewer] is initially "On".
z When the [Scan&Save] button is pressed (when [Scan Viewer] is "Off"),
after the last page is displayed on the "Scanning" screen, the scan data is
saved, and the touch panel screen returns to the "Main Menu".
For more details, refer to "6.10 Enabling/Disabling the Scan Viewer"
(page 393).
To Next Page
Loading...
