Fujitsu FI-6010N - Page 537

fi-6010N Network Scanner Operator's Guide 501
E
System Status Cannot read data from a scanner unit. Try the following:
z If the scanner does not restart
automatically, press the
[Shutdown] button on the
"Login" screen to turn the
power off, and turn the power
back on again to restart the
scanner.
z If the error status persists after
the scanner is restarted, press the
[Shutdown] button on the
"Login" screen, disconnect the
AC cable from the scanner to
turn the power off, wait for at
least 10 seconds, then reconnect
the AC cable and try turning the
power back on again. If the error
status persists, contact your
FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
Usage Status Cannot read data from a scanner unit. Try the following:
z If the scanner does not restart
automatically, press the
[Shutdown] button on the
"Login" screen to turn the
power off, and turn the power
back on again to restart the
scanner.
z If the error status persists after
the scanner is restarted, press the
[Shutdown] button on the
"Login" screen, disconnect the
AC cable from the scanner to
turn the power off, wait for at
least 10 seconds, then reconnect
the AC cable and try turning the
power back on again. If the error
status persists, contact your
FUJITSU scanner dealer or an
authorized FUJITSU scanner
service provider.
Screen Message Action