Fujitsu PRIMERGY RX2540 M6

5.4 Installing the server in the rack
5.4.1
Overview
CAUTION
▶
Please observe the safety information and notes on rack mounting
in "Important information" on page
47 and "Installing the server in
the rack" on page 63.
▶
At least two people are needed to install/remove the server in/from
the rack. (For Japan, see "安全上のご注意".)
▶
Do not extend more than one unit out of the rack simultaneously
even if the tilt protection is in place. If several units are
simultaneously extended out of the rack, there is a risk that the rack
could tip over
.
Fujitsu rack systems
The rack systems from Fujitsu support the installation of PRIMERGY servers:
–
PRIMECENTER rack
–
PRIMECENTER M1 rack
–
DataCenter rack
–
19-inch standard rack (for Japan)
–
19-inch slim rack (for Japan)
For information on mounting the server in the rack, see the "Mounting
Instructions" provided with the Rack Mounting Kit. For more information,
see the manual of your rack system.
For Japan, see also the "Rack system structure guide".
Online documentation for rack installation can be found at https://
support.ts.fujitsu.com under Product - Rack & Components.
For Japan:
https://jp.fujitsu.com/platform/server/primergy/manual/peri_rack.html
Starting up
64 Operating Manual RX2540 M6