5.5 Connecting cables
5.5.1
Notes on connecting/disconnecting cables
CAUTION
▶
Always read the documentation supplied with the device you wish
to connect.
▶
Never connect, or disconnect cables during a thunderstorm.
▶
Never pull on a cable when disconnecting it. Always take hold of
the cable by the plug.
▶
Follow the sequence described below to connect or disconnect
external devices to or from the server
.
▶
Ensure that you wait for 10 seconds or more after shutdown before
turning the server on.
Connecting cables
▶
Switch of
f the server and equipment switches.
▶
Disconnect all power cords from the properly grounded power outlets.
▶
Disconnect the DC power cord with earth grounding conductor from the
properly DC source and earth ground stud or end.
▶
Connect all cables to the server and peripherals.
▶
Connect all data communication cables into the utility sockets.
▶
Connect all power cords into the properly grounded power outlets.
▶
Connect the DC power cord with earth grounding conductor from the
properly DC source and earth ground stud or end.
Disconnecting cables
▶
Switch off the server and equipment switches.
▶
Disconnect all power cords from the properly grounded power outlets.
▶
Disconnect the DC power cord with earth grounding conductor from the
properly DC source and earth ground stud or end.
Starting up
RX2540 M6 Operating Manual 69
To Next Page
Loading...
