▶
When using a RAID array
, add the additional HDD to the RAID array.
Configuring the RAID array, refer to the documentation of the RAID
controller, used in your configuration, see "Documentation overview"
on page 15.
6.4.2 Installing 2.5-inch HDD/SSD modules
Removing a 2.5-inch HDD/SSD dummy module
Figure 36: Removing a 2.5-inch HDD/SSD dummy module
▶
Press both tabs together (1) and pull the dummy module out of its bay (2).
CAUTION
▶
Keep the dummy module for future use.
▶
Always replace dummy modules into unused HDD/SSD bays to
comply with applicable EMC regulations and satisfy cooling
requirements.
Operation
RX2540 M6 Operating Manual 89
To Next Page
Loading...
