5.6 Switching on the server for the first time
CAUTION
▶
The On/Off button does not disconnect the server from the mains.
T
o completely disconnect it from the mains, remove the power
cords from the PSUs.
▶
Do not move, strike, or shake the server when it is switched on.
This can damage the HDD/SSD in the server and cause data loss.
▶
Switch the server on when the temperature is in the specified
temperature range. For more information on the operating
environment, see " Ambient conditions" on page 111. When
operating the server out of the specified temperature range, the
server may operate improperly and data loss may occur.
Furthermore, Fujitsu cannot be held responsible for any related
damage, malfunction, or loss of data, etc.
▶
Ensure that you wait for 10 seconds or more after power off before
switching on the server again.
▶
After connecting all power cords, wait at least 10 seconds before
pressing the On/Off button.
Switching the server on
The AC connected indicator lights up white (standby mode) when the server is
connected to the mains.
It will take about 60 seconds until the server can be switched on.
Starting up
For Japan, see "はじめにお読みください".
▶
Press the On/Of
f button.
▶
Configure your server and install the operating system, see "Configuring the
server with ServerView Installation Manager" on page 78.
Starting up
RX2540 M6 Operating Manual 77
To Next Page
Loading...
