▶
"Removing the bay cover" on page 40.
▶
"Shutting down the server" on page
41.
▶
"Disconnecting the power cord" on page 42.
▶
"Getting access to the component" on page 43.
Removing the bracket wall bay 1
CAUTION
▶
You cannot install the bracket wall again.
▶
Only remove metal bay cover before installing ODD drive to comply
with applicable EMC regulations and satisfy cooling requirements.
If bay 1 is to be equipped, it is necessary to remove its front bracket wall.
Figure 102: Removing the bracket wall bay 1
▶
Insert the screw driver into one slot (see circles) and twist it to breack out
the bracket wall.
▶
Repeat with the other slot.
Accessible drives
TX1310 M5 Upgrade and Maintenance Manual 159
To Next Page
Loading...
