9. FILE OPERATIONS
9-2
3. Tap desired file format, among [TZX], [TZD], [CSV], [GPX].
[TZX]: For NavNet TZtouch2/3
[TZD]: For NavNet TZtouch2
[CSV]
*1
: For NavNet3D
[GPX]
*2
: For use with PC plotter
*
*1
: The CSV format has the following export restrictions:
*2
: When exporting data in GPX format, it is recommended to make a note of the
data contained in the file. GPX files names do not indicate their contents.
4. Tap the close button to finish.
9.2 How to Export User Objects
This unit holds a maximum of 30,000 points, 200 routes, 100 polygon areas, (bound-
aries), 100 circles (boundaries), 1,000 screenshots, and 1,000 catches. When the ca-
pacity for routes/points is full, new data cannot be stored. If you need to save the
above-mentioned items permanently, save them to a media, following the procedure
below.
1. Put the appropriate formatted media in the USB port or a slot in the SD Card Unit.
For TZTL12F/TZTL15F users: Put a formatted microSD card in either slot on the
SD Card Unit.
For TZT2BB users: Put a formatted SD card in the right-hand slot of the Switch
Box (PSD-003).
2. Open the Home screen, then tap [Settings][Files][Export User Objects].
3. Tap [SDCardRight] (or [SD CardLeft]) on the SD card unit, [External] for USB port,
or [Power Switch Left] (or [Right]) for Switch Box PSD-003. You are asked if you
are sure to export points and routes.
4. Tap [OK]. The message "EXPORT SUCCEEDED" appears if the exporting was
successful.
5. Tap [OK].
6. Tap the close button to finish.
• Points: Max. 2,000
• Routes: Max. 200 (100 points/route)
• Track: Max. 10,000
To Next Page
Loading...
Need help?
General
