10. CAMERA/VIDEO/EXTERNAL EQUIPMENT
10-3
Video Input 1/Video Input 2 (analog, FLIR)
Connected: Turn on to use the device (video equipment, FLIR camera) connected to
the VIDEO-IN1, VIDEO-IN2 port.
Nickname: If desired, you change the name of the analog camera(s). The default
names are [CAMERA1], [CAMERA 2]. You can use a maximum of 20 characters. To
change a name, tap [NickName] to show the software keyboard. Change the name,
then tap [] to finish. The name is reflected to the following locations.
• The name that appears at the bottom right corner of the camera display.
• Home screen[Settings][Camera][FLIR Installation][Video Source]
• Pop-up menu that appears when you tap the camera display.
IP camera
The IP address and the signal name for the IP camera signal can be changed as
shown below. Additionally PTZ control can be turned on or off.
Note: [PTZ Control] should only be used when the connected camera is compatible
with the PTZ function. Activating the [PTZ Control] function when the camera is not
compatible may cause problems with this equipment's regular functions.
To Next Page
Loading...
