Furuno NAVnet TZtouch2 - Page 329

15. OTHER FUNCTIONS
15-10
15.4 Facsimile Receiver FAX-30
The FURUNO Facsimile Receiver FAX-30 installs in the NavNet TZtouch2 network
and can be controlled from a NavNet TZtouch2 display. Below are the steps to start
fax operation.
1. Connect the FAX-30 to the NavNet TZtouch2 network.
2. Open the home screen, then tap "Fax30" (left side of screen).
3. Tap [WX FAX] or [NAVTEX].
4. Refer to the Operator’s Manual of the FAX-30 for operation information.
The FAX-30 display can only be accessed by one NavNet TZtouch2 unit at a time.
When another NavNet TZtouch2 display accesses the FAX-30, control of the FAX-30
is given to that display after the picture has stopped completely. This sequence takes
approximately one minute.
FAX-30 Browser
FAX-30 Browser