15. OTHER FUNCTIONS
15-9
Others menu items
Menu item Description Option (setting range)
[Chart Master Device] Set to ON to set this equipment as the chart master and share one System
ID and chart unlock code in the network.
Note 1: For monitors connected to the TZT2BB via the HDMI OUT2 port,
the menu items [Connect to the Internet] and [Wireless LAN Settings] do not
appear in the [General] menu.
Note 2: If you change the setting for [Master Chart Device] to [OFF], the
message "Charts have to be unlocked again if you change the Chart Master
device. Are you sure you want to proceed?" appears. Tap [OK] to change
the device, or tap [CANCEL] to cancel.
[System ID] The system ID for this device within the network.
[IP Address] IP address for this unit within the network.
[Quick Self Test] Test the equipment.
[Certification Mark] Show the certification marks this equipment has received.
[ServiceMan] Requires login password. For the service technician only.
[Event Input
Configuration]
These menu items are not used.
[Update Network
Equipments]
Updates all NavNet equipment in the network. For the service technician.
[Remote Controller
Configuration]
When there are multiple units in the NavNet network, the Remote Controller
MCU-004/MCU-005 can select the display to show on the unit with Remote
Controller connection. Further, the cycling order of displays can be set. See
section 1.2.2 (MCU-004) and section 1.2.3 (MCU-005).
[Adjust Display
Resolution]
Adjust the output resolution from the TZT2BB to match the connected mon-
itor’s resolution.
Note: This menu item does not appear for TZTL12F/TZTL15F systems.
[Sirius Radio
Diagnostic]
Check the satellite radio of the FURUNO BBWX weather receiver for proper
operation. See section 13.7.3.
[Sirius Weather
Diagnostic]
Check the weather section of the FURUNO BBWX weather receiver for
proper operation. See section 13.6.
[Reset Default
Settings]
Reset the system to default settings.
To Next Page
Loading...
