GT7 Terminal
Introduction
12
HB_GT7-2x00-3x00--EN_12
www.gantner.com
CAUTION! Injury and property/equipment damage. The tasks described in each chapter must only be
performed by the specified target group. Unqualified personnel who perform the described tasks risk personal injury
or damaging property/equipment.
1.4 Formatting
1.4.1 General Information
The following formatting (with example text) is used in this manual to display important, but not safety-critical
information.
The text accompanying this symbol contains interesting information relevant to the current chapter. You do not
necessarily need to read this text, however; it will help you to understand the information in the section or
provide interesting tips for the described device or the operation of the software.
1.4.2 Safety-Critical Information
The following formatting (with example text) is used in this manual to display important, safety-critical information
that must be read and followed.
NOTE! Following on from this signal word in the manual is a reference text that must be read and followed. The
reference text contains important information. Non-observance can result in damage to the device or associated
equipment.
1.4.3 Instructions and Results
Instructions, which must be completed by the reader, and the results of these instructions are formatted as follows.
► This symbol represents an action or instruction that that must be followed.
o This symbol represents the result after completing the previous instruction.
1.5 Contact & Inquiries
If you have any questions concerning the GT7 terminal, or with any of the other hardware/software products mentioned,
please contact your local sales partner or one of the GANTNER branch offices directly. The contact details are
available via the following link: www.gantner.com/locations
To Next Page
Loading...
Need help?
General
