Gantner GT7.2x00 - Page 76

GT7 Terminal
Technical Data
76 HB_GT7-2x00-3x00--EN_12 www.gantner.com
Signal input
- Optocoupler: 1 x optocoupler input, potential-free, function configurable
Input voltage: DC 0 to 30 V (U
Low
< 2 V, U
High
> 6 V)
- Wiegand (DATA, CLK): 2 x input, with potential, function configurable
Input voltage: open or GND (e.g., push button connected to GND)
Signal output GT7.2x00: 1 x relay
GT7.3x00: 2 x relays
- Type: NO contact, function/timing configurable
- Switching voltage DC: max. 30 V (SELV)
- Switching voltage AC: max. 15 V (SELV)
- Continuous current: max. 1.8 A
- Switching capacity: max. 54 W, 27 VA
Host interface
- Ethernet: 10/100 Mbps, IPv4 and IPv6
- WLAN: IEEE 802.11b/g/n
Reader interfaces: - RS-232 (barcode)
- RS-485 (GANTNER expansion bus)
- Wiegand
Connection: Screw terminals, 0.5 - 1.5 mm
Software integration: - JSON interface
- Generation 6 compatibility adapter (limited functions)
Housing
- Front/rear part: Plastic PC black gray
- Reader cover: Plastic PC In-mould technology
- Display: Hardened glass
Weight: 370 g (13 oz)
Permitted ambient temperature: -10 to +50 °C (+14 to +122 °F)
Storage temperature: -25 to +70 °C (-13 to +158 °F)
Protection type: IP 54 (installed state)
Protection class: III (Safety Extra-Low Voltage)
Environment class (VdS 2110): III (outdoor conditions, weather protected)
Compliances
- GT7.x300: CE
- GT7.x500: CE, CB, FCC, IC, ETL, EAC
- GT7.x700: CE, FCC, IC