GE Security CS575 - Configuring AL2 Supervised ISDN Connection; Uploading and Downloading

CS875-575-375-275-175 Installers Manual with CS5500 keypadB.16.8
4. The keypad beeps once to accept the change and returns to Phone Number.
5. Scroll to Account Code and press OK.
6. Enter
445566 and press OK.
7. The keypad beeps once to accept the change and returns to Account Code
8. Scroll to Protocol>SIA and press OK.
9. The keypad beeps once to accept the change and returns to Protocol.
10. Scroll to Events>Arm/Disarm/Alarm>Alarms and press OK.
11. The keypad beeps once to accept the change and returns to Alarms.
16.3.2 Configuring AL2 supervised ISDN connection
If you are using the AL2 supervised ISDN connection, you must also program the D channel polling and D
Channel Terminal Equipment identifier (TEI) options as well as the phone number, account code, protocol and
events. The following example reports alarm events to phone number 02048888999, account code 55555 using
the Alphacom X25 D-channel protocol.
1. Navigate with the µ¶ keys to CS7501 ISDN Dialler>Reporting>Phone Numbers and press OK.
2. Scroll to Phone Number 1>Phone Number and press OK.
3. Enter 020488899 and press OK.
4. The keypad beeps once to accept the change and returns to Phone Number.
5. Scroll to Account Code and press OK.
6. Enter 55555 and press OK.
7. The keypad beeps once to accept the change and returns to Account Code
8. Scroll to Protocol> Alphacom D-channel and press OK.
9. The keypad beeps once to accept the change and returns to Protocol.
10. Scroll to Events and enable all events that must be reported to central station.
11. Navigate with the µ¶ keys to CS7501 ISDN Dialler>Options>ISDN>D-Ch Polling and press OK.
12. Scroll to D-Ch Polling>5 min. and press OK.
13. The keypad beeps once to accept the change and returns to D-Ch Polling.
14. Scroll to D-Ch TEI>8 and press OK.
15. The keypad beeps once to accept the change and returns to D-Ch TEI.
 Default are all events enabled in dialer.
16.3.3 Uploading and downloading
There are two methods for up/downloading , call back or start u/d with code.
When using the CS534, the ISDN dialler differentiates between these two methods.
• For listen-in via call back, the ISDN listens for 5 seconds to check if a DTMF tone 0 was entered for a period
of 1 second.
• If no DTMF tone was recognised the ISDN starts an up/download session.