Full test
The Full Test or the individual tests must be performed at least once
within every 24-hour period.
Perform the Full Test at the start of each day. The full test runs
automatically and beeps to indicate when it is finished or if
interaction is required.
The Full Test does the following tests: Vent and Gas, Circuit Leak,
and Circuit O2 Cell
(if circuit O2 cell is present). When one of the
tests is completed, the next test begins.
1. From the Checkout menu, select Full Test and follow the
instructions.
2. If a test fails, follow the instructions to perform a retest or accept
the results.
3. When the Full Test is completed, start a case.
In case of a patient emergency, the Full Test may be bypassed by
selecting Start Case. The general message ‘Please Do Checkout’ is
displayed if a Full Test or all of the individual tests are not completed
with passing results within 24 hours.
Vent and gas
The Vent and Gas test checks the agent delivery, airway module,
Bag/Vent switch, proper gas supply pressures, ventilator operation
and leak, battery and electrical power, circuit compliance, and flow
control operation. This is a two-step test.
To run this test, follow the on-screen instructions. When the test
passes, the next test starts.
Any cassette may be used during the test. Use a non-desflurane
cassette during the test to check the full functionality of the internal
electronic control unit.
Circuit leak
The Circuit Leak test checks the Bag/Vent switch, proper gas
supply pressures, airway pressure measurement transducer, APL
valve, and manual circuit leak.
To run this test, follow the on-screen instructions. When the test
passes, the next test starts.
Note
Note
Aisys CS²
5-6 2067226-001
To Next Page
Loading...
Need help?
General
