GE auisys cs2

4. To change ventilation mode, select Mode. Make the change.To
change the ventilation settings, select a ventilator quick key or
More Settings. Make the change.
5.
To change alarm settings, select Alarm Setup. Make the
change.
6. To change the gas settings or the circuit type, select Gas Setup.
Make the change.
7. From the Start Case menu, select Start Case Now. Gas flow
starts.
See the "Ventilator setup" section for information on the Vent Mode
menu.
See the "Gas setup" section for information on the Gas Setup menu.
See the "Alarm setup" section for information on the Alarm Setup
menu.
End a case
Use the End Case menu to stop gas flow and end the patient
alarms.
1. Set the Bag/Vent switch to Bag.
2. Select End Case.
3. Select End Case Now on the menu to put the system in standby
(stops the gas flow and patient alarms). The End Case menu
shows the gas and agent usage for the case.
Aisys CS²
3-6 2067226-001