Display optional output
ports
Cables used for EMC testing
Monitor On/STBY Standard 9-pin D-subminiature male
connector with shielded cable - 1.8 m
maximum length.
Guidance and manufacturer’s declaration - electromagnetic
emissions
The system is suitable for use in the specified electromagnetic
environment. The customer and/or user of the system should assure
that it is used in an electromagnetic environment as described below.
.
Emissions test Compliance Electromagnetic environment guidance
RF emissions
CISPR 11
Group 1 The system uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
RF emissions
CISPR 11
Class A The system is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic
emissions IEC
61000-3-2
Class A The system is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Voltage
fluctuations/flicker
emissions IEC
61000-3-3
Complies The system is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Guidance and manufacturer’s declaration - electromagnetic
immunity
The system is suitable for use in the specified electromagnetic
environment. The customer and/or user of the system should assure
that it is used in an electromagnetic environment as described below.
11 Specifications and theory of operation
2067226-001 11-47