Gas controls
Use the Gas Controls menu to set the user’s Agents, Total Flow,
and O2%
quick select preset values and the Fresh Gas Controls
setting.
Setting gas preset values
Set five preset gas values that will show on the user’s Gas Setup
menu for Agents, O2%, and Total Flow. Set two combinations of
preset values for O2% and Total Flow.
1. From Super User, select Gas Controls.
2. Select Agents, O2%, Total Flow, or O2% and Total Flow.
3. Set the desired preset gas values.
4. Select Back to return to the Gas Controls menu.
Setting fresh gas controls
1. From Super User mode, select Gas Controls.
2. Set Fresh Gas Controls to O2%, Flow, or User from the drop-
down list.
If User is selected, the user will be able to select either O2% or
Flow for a case.
3. Select Close to exit.
12 Super user mode
2067226-001 12-15
To Next Page
Loading...
Need help?
General
