2. Select Cycling.
3.
Select a Procedure to perform.
4. Select Start Cycling.
The procedure begins.
Procedure progress shows in the procedure window.
5. Stop the procedure anytime by selecting Stop Cycling.
6. Select Close.
Changing cycling settings
1. Select Procedures.
2. Select Cycling.
3. Select a Procedure to perform.
4. Select Adjust Settings.
The first setting of Step 1 in the procedure window is selected.
5. Push the ComWheel to enter the adjustment window.
6. Use the ComWheel to navigate the adjustment window and
change a value.
7. Select Start Cycling.
8. Select Close.
Aisys CS²
3-30 2067226-001
To Next Page
Loading...
