GE Dash 4000 Service Manual

Field replaceable units: Recommended checkout
2000966-542D Dash 3000/4000/5000 7-53
DAS assembly “NBP
calibration” on
page 8-37.
 “ECG tests” on page 8-22.
 “Respiration tests” on page 8-25.
 “Temperature tests” on page 8-26.
 “Cardiac output tests (option)” on page 8-27.
 “Invasive blood pressure tests (option)” on
page 8-27.
 “Pulse oximetry tests for GE Ohmeda SPO2
oximeter” on page 8-30. Use this procedure if
you installed a GE Ohmeda DAS assembly.
 “Pulse oximetry tests for Masimo SET SPO2”
on page 8-32. Use this procedure if you
installed a Masimo DAS assembly.
 “Pulse oximetry tests for Nellcor OxiMax SPO2”
on page 8-33. Use this procedure if you
installed a Nellcor OxiMax DAS assembly.
 “Noninvasive blood pressure tests” on page 8-
35.
 “Wireless antenna signal strength test (option)”
on page 8-49. Use this procedure if the wireless
option is installed.
 “Wireless LAN test (option)” on page 8-52. Use
this procedure if the wireless option is installed.
 Refer to the CO2 chapter in the patient
monitor’s operator manual to checkout the
mainstream End-tidal CO2.
 To check out the sidestream End-tidal CO
2
,
refer to the documentation that came with the
module.
 “Electrical safety tests” on page 8-4.
Recommended calibration, electrical safety tests, and checkout procedures
Replacement
procedure
Calibration
tests
Checkout procedures Electrical safety tests

GE Dash 4000 Specifications

General

Resolution	640 x 480 pixels
Power Supply	100-240 VAC, 50/60 Hz
ECG	3/5/12-lead
IBP	Up to 4 channels
Battery Backup	Yes
Certifications	CE, UL, CSA
Parameters Monitored	ECG, SpO2, NIBP, IBP, Temperature, Respiration, Cardiac Output
Connectivity	Ethernet, USB, Serial
Display Type	TFT LCD
Recorder	Integrated thermal printer
Battery Type	Lithium-ion
Operating Temperature	0 to 40°C
Storage Temperature	-20 to 60°C
Humidity Range	15% to 95% non-condensing
Display Size	10.4 inches
Cardiac Output	Available