GE LPS-O - Page 241

GE Power Management LPS-O Line Protection System 11-
15
11 LPSO-LINK USER GUIDE 11.4 SETTING UP YOUR HOST MACHINE
11
Clicking on
Use As Default
button will save the parameters for the device and also makes them as the default
values. By selecting the most common device parameters as default will simplify the addition of a device to the
system. So, next time you want to add a device, the device setup dialog box appears with these default param-
eters.
If you want to setup a new device by copying information from an existing device setup to a new one, you can
use the
Copy From
option. Choose this button to display a list box with the existing devices. Select a device
and choose the
OK
button to proceed. All the device setup parameters of that device are displayed under the
device currently being edited. If any modifications are required, you can do them. You can save the new device
with these parameters or
Cancel
to quit without saving.
To modify the parameters for an already existing device, select the device from the Device Directory dialog box
and choose the
Modify
button. The device setup dialog box appears with all the parameters of that device. Do
the necessary modifications and save or quit.
To delete a device from the system, select the device from the
Device Directory
dialog box and choose the
Delete
button. A message box requesting the confirmation for the deletion appears. Choose the
Yes
button to
proceed with the deletion. Choose the
No
button to quit deleting the device from the list.