GE LPS-O - Page 261

GE Power Management LPS-O Line Protection Relay 12-
7
12 ASCII COMMUNICATIONS 12.1 INTRODUCTION
12
TIMe Displays the current LPS-
O time
SETTINGS Do you want to chan
g
e time? (Y/N):
Enter new time (hh:mm:ss):
Command is executed
Enter letter Y or
N; 6 di
g
it time
code
LINEs Chan
g
es the number of
lines the relay will display
before pausin
g
for the user
to read
VIEW Enter the number of LINES PER PAGE (24/25/48/
50):
Enter 24, 25, 48,
or 50
GEModem Chan
g
es communications
type to GE-Modem after
user has lo
gg
ed out
SETTINGS None
ECHo To
gg
les the echo state and
reports its status
VIEW Echo is turned ON (OFF) None
PORTparam Chan
g
es and displays the
current port parameters for
the LPS-O serial
communications port
SETTINGS Do you want to chan
g
e communication port
parameters? (Y/N):
Interface is (0 - RS232, 1 - RS485): 0
Enter Interface Type (0 - RS232, 1 - RS485):
Baud rate is 9600
Enter baud rate (19200, 9600, 4800, 2400, 1200,
300):
Parity check type is (0 -none, 1 - odd, 2 - even): 0
Enter parity check type (0 -none, 1 - odd, 2 - even):
Number of stop bits is 1
Enter number of stop bits (1 or 2):
Save chan
g
es? (Y/N):
Y displays
parameter to be
chan
g
ed, N
exits; 0 for
RS233, 1 for
RS485; press
ENTER for no
chan
g
e; choose
baud rate
matchin
g
PC
port; Enter 0, 1,
or 2;
Enter 0, 1, or 2;
Enter Y or N
END Ends the session VIEW None
Table 12–3: ASCII COMMAND LIST
(Sheet 6 of 7)
ASCII
Command
Mnemonic
Command Description Lowest
Level
Password
Needed
Relay Prompt User Response