36 SD Series Technical Manual MDS 05-4846A01, Rev. D
View/Set Radio (RF) Operating Parameters
Set RF Output Power, Modem Type, RX/TX
Frequency
Configuration>>Radio,
Basic Settings, Page 39
View/Set Soft-Carrier Dekey status, RX/TX
Time-Out options
Configuration>>
Radio>>
Advanced Settings, Page 45
Data-Key and RTS-Key settings (ON/OFF) Configuration>>
Radio>>
Advanced Settings, Page 45
Push-to-Talk/Clear-to-Send Delay times (ms) Configuration>>
Radio>>
Advanced Settings, Page 45
Automatic Frequency Correction (AFC) setting Configuration>>
Radio>>
Advanced Settings, Page 45
Switched Carrier ON/OFF setting (B Modems) Configuration>>
Radio>>
Advanced Settings, Page 45
Configure Listen-Before-Transmit (LBT)
collision avoidance
Configuration>>
Features>>
LBT Settings, Page 47
View Received Signal Strength (RSSI) level Maintenance & Status>>
Performance, Page 57
Key the radio transmitter, view power output Maintenance & Status>>
Radio Test>>
RF Keying Test, Page 60
Monitor local radio emissions for possible
interference
Maintenance & Status>>
Radio Test>>
Spectrum Graph, Page 60
View/Set Device Configuration
View Serial No., Model 1 (hardware), Model 2
(software) version, Firmware Version, Build
Date
Overview>>
SD Summary, Page 34
Set Owner Name/Message, enable/disable
Sleep Mode, set COM LED mode, Radio Mode
Configuration>>
Radio>>Device Settings,
Page 41
Configure time delays to identify packets on
serial ports
Configuration>>
Radio>>
Packet Settings, Page 42
Configure Media Access Control (MAC) settings Configuration>>
Radio>>
Media Access Control>>
Settings, Page 43
Configure Unit ID and/or DLINK diagnostics
settings
Configuration>>
Radio>>
Diagnostic Settings, Page
44
Table 11. Common Tasks with Device Manager (Continued)
Task
Category
If you wish to... Refer to this Screen
To Next Page
Loading...