MDS 05-4846A01, Rev. D SD Series Technical Manual 37
Security Settings
Set Password for radio Configuration>>
Security>>
Login Password, Page 53
Set Device Security (enable/disable local login
requirement, enable/disable Telnet access)
Configuration>>
Security>>
Device Security, Page 52
Set Wireless Security parameters (Encryption
on/off, phrase, DLINK Security on/off)
Configuration>>
Security>>
Wireless Security, Page 53
Ethernet Port
Configuration
Configure the IP settings (Static IP Address,
Static IP Netmask, Static Default Gateway,
DHCP enable/disable, Virtual Radio
Channels–VRCs)
Configuration>>
Communication Ports>>
IP Configuration, Page 51
Configure Ethernet Bridging Configuration>>
Features>>
Bridge Configuration, Page
47
Configure the Ethernet Port settings
(Enable/disable port, set mode, Local IP Port,
Destination IP Address, Destination IP Port,
TCP Keepalive time)
Configuration>>
Communication Ports>>
IP Configuration, Page 51
Serial Port
Configuration
Configure COM1 settings (Startup mode, Data
Baud Rate, Data format, Virtual Radio
Channels–VRCs)
Configuration>>
Communication Ports>>
COM1 Port Settings, Page
50
Configure COM2 settings (Mode, Baud Rate,
Format, Buffer on/off, Device Type, Virtual
Radio Channels–VRCs)
Configuration>>
Communication Ports>>
COM2 Port Settings, Page
50
Table 11. Common Tasks with Device Manager (Continued)
Task
Category
If you wish to... Refer to this Screen
To Next Page
Loading...