GE P741

Commissioning
P74x/EN CM/Na7
MiCOM P741, P742, P743
(CM) 10-63
CM
11.2.3 Control and support settings
0700 CB CONTROL
Prot Trip Pulse ________________s
Trip Latched

Disabled

Enabled
If visible Reset Trip Latch

Yes

No
CB Control By [ ________________ ]
with: [1] = Disabled, [2] = Local, [3] = Remote, [4] = Local + Remote,
[5] = Opto, [6] = Opto + local, [7] = Opto + Remote, [8] = Opto + Remote + local
If visible Man. Close Pulse ________________s
If visible Man. Trip Pulse ________________s
If visible Man. Close Delay ________________s
If visible 87BB Trip delay ________________s
If visible CB Superv Timer ________________s
0A00 CT AND VT RATIOS
Phase CT Primary ________________A
Phase CT Secondary ________________A
RBPh / RBN ________________
Power parameters
Standard Input

British standard

IEC
British Knee Voltage Vk
________________ I
n
V
IEC Rated Burden VA ________________A
IEC Rated Burden Ohm
________________Ω
IEC KSCC ________________
IEC RCT Sec'y ________________m
Eff. Burden Ohm
________________Ω
IEC Eff. Burden VA ________________VA
0B00 RECORD CONTROL
Alarm Event

Disabled

Enabled
Relay O/P Event

Disabled

Enabled
Opto Input Event

Disabled

Enabled
General Event

Disabled

Enabled
Fault Rec. Event

Disabled

Enabled
Maint. Rec Event

Disabled

Enabled
Protection Event

Disabled

Enabled