8-6 Section 8-3 - Covers - Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-3-1-1 Preparations
Shut down the Venue™ ultrasound unit, as described in Power Shut Down .
8-3-1-2 Preparation for Cover Installation
Replacement covers for the Venue™ are supplied with the required securing screws and ball stud/ball
stud receptacles. Before installing a replacement cover, it is necessary to fit these in the appropriate
positions. Refer to the illustrations provided in the specific Cover Replacement procedure.
ELECTRICAL HAZARDS EXIST AT SEVERAL POINTS IN THE SYSTEM.
FAMILIARIZE YOURSELF WITH ALL HAZARDOUS VOLTAGES AND
HIGH CURRENT LEVELS BEFORE REMOVING ANY OF THE COVERS.
DO NOT WEAR THE ESD WRIST BAND STRAP WHEN REMOVING
PARTS FROM THE POWER SUPPLY UNIT. BEFORE REMOVING ANY
PART OF THE POWER UNIT, TURN THE POWER OFF AND
DISCONNECT THE POWER CORD.
BEFORE REMOVING CIRCUIT BOARDS, TURN THE POWER OFF AND WEAR THE ESD WRIST
BAND STRAP.
To Next Page
Loading...
