Chapter 8 - Replacement Procedures 8-39
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-4-5-5 Cockpit (Monitor) Installation Procedure
1.) Mount the cockpit (monitor) on the mounting hooks and secure with four Phillips screws.
2.) Reconnect the cockpit (monitor) cables:
• BE TO COCKPIT CABLE
• MPB TO COCKPIT CABLE
• Ground cables (x2)
• Rear cable cover (if exists)
3.) Reinstall the Gel Holder.
Figure 8-27 Installing Cockpit (Monitor)
Perform the checks listed in Cockpit (Monitor) Replacement Procedure on page 8-217
To Next Page
Loading...
