8-48 Section 8-4 - System Modules- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
8-4-8-5 BE Module Installation Procedure
1) Hold the SSD cables and slide in the BE module half way into the eTower.
2) Connect the MPB to BIB cable.
3.) Fully insert the BE module into the eTower and secure the two captive screws.
4.) Reconnect the following cables:
• MPB to BIB
• MPB to BEP (white)
• Cockpit to BEP split cable (green and black)
• Printer cable (yellow)
Use the following diagram for reference:
5.) Reconnect the BIB blue cable to the CFE plastic cable guide.
6.) Reconnect the MPB to BE power cable.
7) Install the SSD module.
8) Close the FE door and close the two fastening latches on the left side of the Front End door
assembly.
9.) Tighten the captive screw.
10) Install the MPB Front Metal Door.
11.)Refit the following covers: left side eTower, right side eTower, and RS Probe Cover.
Figure 8-35 BE Cable Connection Diagram
• SSD Module Installation Procedure
• MPB Front Metal Door Installation Procedure
To Next Page
Loading...
