Chapter 8 - Replacement Procedures 8-117
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
3.) Remove the lower and then the upper cockpit covers.
4.) Apply moderate force and route the MPB to Cockpit cable through the tilt axis, keeping the routed
cable on the most left, and the connector facing to the right. Make sure it is routed above the tilt
release cable wire.
Figure 8-105 Removing Upper and Lower Cockpit Covers
Figure 8-106 Routing the MPB to Cockpit Cable through Tilt Axis
Upper cover removed
Lower cover removed
Connector facing
to the right
To Next Page
Loading...
