Chapter 8 - Replacement Procedures 8-183
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
3.) Gently pull out the ECG module.
4.) Disconnect the USB cable and remove the ECG.
8-8-5-5 ECG Installation Procedure
1.) Connect ECG to the USB cable.
2.) Insert the ECG module all the way in.
3.) Tighten the ECG securing screw.
4.) Install the following covers: Upper Front eTower, Lower Front eTower.
Figure 8-205 Pulling Out ECG
Figure 8-206 Removing ECG
• Upper eTower Front Cover Installation Procedure
• Lower Front eTower Cover Installation Procedure
To Next Page
Loading...
