GE Venue R2

8-88 Section 8-6 - Mechanical Parts- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
10.)Pull out the cockpit (monitor) cables routed inside the riser.
11.)Disconnect the ground cable from the riser
12.)Using Forged Steel Ring Pliers, remove the C-clip and then the Teflon ring.
Figure 8-70 Removing Cockpit (Monitor) Cables
Figure 8-71 Removing Ground Cable
Figure 8-72 Removing Teflon Ring and C-clip
Teflon ring
C-clip
C-clip
Teflon ring