GE Venue R2

8-122 Section 8-6 - Mechanical Parts- Replacement Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
21.)Install the MPB module.
22.)Refit the following covers: Riser Thermal, Left Side eTower, Right Side eTower, Lower Front
eTower, and RS Probe cover.
23.)Install the rear cockpit cable cover if exists.
24.)Connect the Wi-Fi dongle if exists.
25.)nstall all accessories.
26.)Turn ON power to the system.
• MPB Module Installation Procedure
• Riser Thermal Cover Installation Procedure
• Left Side eTower Cover Installation Procedure
• Right Side eTower Cover Installation Procedure
• Lower Front eTower Cover Installation Procedure
• RS Probe Cover Installation Procedure
• Wi-Fi Adapter Installation Procedure (For Systems with No Existing Wi-Fi Adapter)
• Accessories - Replacement Procedures
Perform the checks listed in Articulated Arm Replacement Procedure on page 8-218