8-166 Section 8-8 - Peripherals Replacement/Installation Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
4.) Remove the MPB Front Metal Door.
5.) Unclip the white plastic cable holder and release the two printer cables: Printer Power Cable and
Printer USB Cable
6.) Attach bracket to the Printer and tighten the four Phillips screws (the bracket and the screws are
supplied with the printer kit).
• MPB Front Metal Door Removal Procedure
Figure 8-175 Releasing Printer Cables
Figure 8-176 Attaching Bracket to Printer
To Next Page
Loading...
