8-180 Section 8-8 - Peripherals Replacement/Installation Procedures
D
IRECTION 5771498-100, REVISION 6 VENUE™ SERVICE MANUAL
PRELIMINARY
9.) Install the metal bracket.
10.)Connect the USB cable and power cable to the printer and the USB cable to the ECG module.
11.).Using two Thumb screws, install the bracket on the eTower.
12.)Tighten the screw to fix the ECG module in place.
Figure 8-200 Installing Metal Bracket
Figure 8-201 Connecting Printer and ECG Cables
Figure 8-202 Connecting Printer and ECG Cables
To Next Page
Loading...
