page | 132
Advanced Operation
Commands
#set_discovery
Enables or disables the “discovery” feature. This feature is enabled by default.
Syntax
#set_discovery state
Parameters
state
Type: INTEGER
Accepts a number from the table below, specifying the desired state:
state Description
0
Disables “Discovery” mode
1
Enables “Discovery” mode
If set to disabled, then the Syner-G Software Suite will be unable to detect the
matrix on a network. It is recommended that this feature is enabled, until the
matrix has been congured for use on a network.
Example
#set_discovery 0
DISCOVERY 0
Related Commands
#get_discovery
#get_discovery_mode
#set_discovery_mode
Advanced Operation
To Next Page
Loading...
Need help?
General
