Page 112 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
Now enter
☎ “7 0 8 *”
The VRC2000 will report the current condition of status channel 8.
Now enter
☎ “2 0 1 *”
The VRC2000 will respond:
• COMMAND CHANNEL ONE. A ACTIVATED.
The VRC2000 is reporting that command channel 1’s A switch is energized.
Now enter
☎ “2 0 2 * # *”
The VRC2000 will respond:
• COMMAND CHANNEL TWO. A ACTIVATED. B ACTIVATED. A ACTIVATED.
The sequence instructed the VRC2000 to activate command channel 2’s A
switch and B switch, and then to activate the A switch again.
VOICE RESPONSE NOTE:
Although the voice report from the VRC2000 took several seconds, the command
channel switches are activated immediately after you press the “*” or “#”
buttons on your telephone.
Now enter a longer sequence:
☎ “6 1 0 * 6 1 1 * 7 1 2 *”
Listen to the response.
This demonstrates the VRC2000’s capability to accept long sequences of
commands. As long as valid instructions are sent, the VRC2000 will
continue to process the commands and respond to the user. All valid
commands are executed immediately, even though the voice output of the
unit may take some time.
If you enter an invalid command, the VRC2000 will respond with the
ERROR message.
VOICE BUFFER NOTE:
The VRC2000’s electronic voice buffer can hold only 128 words. If the voice
buffer is filled beyond this capacity, some of the words will not be reported. All
commands, however, will be executed.
Now enter
☎ “0 6 0”
Appendix F:
Continued
To Next Page
Loading...