VRC2000 Installation and Operations Manual Page 57
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
The VRC2000 will say
• TIME-OF-DAY SECONDS FOR ENTRY ONE ARE ... {TEN}
You enter
☎ “4 5”
The VRC2000 will respond with a double [BEEP].
Time-of-day function entry one is now set to activate at the forty-fifth second
of the selected minute and hour.
The VRC2000 will say
• TIME-OF-DAY FOR ENTRY ONE IS ... {AM}
You enter
☎ “#”
The VRC2000 will respond with a double [BEEP].
Time-of-day function entry one is now set to activate during the after noon
(PM) portion of the day. In this example, the time selected is 6:30:45 p.m.
Use “#” to program the time-of-day function to activate during the afternoon
(PM), “*” to program the time-of-day function to activate before noon (AM).
The VRC2000 will say
• TIME-OF-DAY DATE FOR ENTRY ONE IS ... {OCTOBER}
You enter
☎ “0 9”
The VRC2000 will respond with a double [BEEP].
Time-of-day function entry one is now set to activate on a day in September.
DATE VS. MONTH NOTE:
The VRC2000’s word list does not contain the word “month.” Therefore, this
parameter uses the word [DATE] to prompt and entry for what month a time-of-
day function should activate.
To disable the date parameter, enter “0 0”. To activate time-of-day functions
weekly, the date parameter must be disabled.
If the date function is disabled, the VRC2000 will say
• DAY OF WEEK FOR ENTRY ONE IS ... {DISABLED}
You enter
☎ “4”
To Next Page
Loading...