Page 58 VRC2000 Installation and Operations Manual
Technical or Setup Assistance
Telephone: 800.945.7730 (USA) or 801.975.7200 (worldwide) • Worldwide Web @ http://www.gentner.com
The VRC2000 will respond with a double [BEEP].
Time-of-day function one is now set to activate on Wednesday; that is, the
fourth day of the week. Use a single digit to enter the day of the week for a
time-of-day function.
To disable the day-of-the-week parameter, enter a “0”. To activate a time-of-
day function every day, the day-of-the-week function must be disabled.
The VRC2000 will say
• TIME-OF-DAY DAY FOR ENTRY ONE IS ... {TEN}
You enter
☎ “0 7”
The VRC2000 will respond with a double [BEEP].
Time-of-day function one is now set to activate at the seventh day of the
selected month. For this example, the VRC2000’s time-of-day function entry
one to is set to activate at 6:30:45 p.m. on September 7.
The VRC2000 will say
• COMMAND CHANNEL NUMBER FOR ENTRY ONE IS ... {ONE}
You enter
☎ “0 4”
The VRC2000 will respond with a double [BEEP].
When the VRC2000 executes time-of-day function entry one, it will now
trigger command channel 4 at 6:30:45 p.m. on September 7. Always use two
digits to enter the command channel number for a time-of-day function.
The VRC2000 will say
• ACTIVE COMMAND CHANNEL SWITCH FOR ENTRY ONE IS ... {A ACTIVATED}
SWITCH IDENTIFIER NOTE:
The VRC2000 will speak whatever words programmed to identify the active
command channel switch for a time-of-day function entry.
You enter
☎ “*”
The VRC2000 will respond with a double [BEEP].
When the VRC2000 executes time-of-day function entry one, it will now
activate command channel 4’s A switch at 6:30:45 p.m. on September 7.
Enter a “*” to specify switch A for the selected command channel; enter a
“#” symbol to specify switch B.
VRC2000 Setup
Continued
To Next Page
Loading...