Gerber Technology GERBERplotter MP Series

29
GERBERplotter MP Series User Manual
English
Connections
Step 15 of 17
After the electronic panel has been installed, connect the following cables.
1
Connect the earth cable from the net lter to the adjacent earth connection.
2
Connect the ribbon cables from the printer bridge to CON8, CON9, and CON10. CON10 is only available
on plotters with four print heads.
3
Connect the black cable from the upper motor to the CON3 connector.
4
Connect the cable from the top cover to the CON43 connector on the main board.
5
Connect the RFID cables to CON28 (red coded cable) matching the red coded connector on the main board.
6
Connect the cable from the printer bridge to the CON29 connector.
7
Connect the cable for the paper advance encoder wheel to the CON5 connector. The yellow coded cable
must match the yellow connector on the main board.
8
Connect the black cable from the lower motor to the CON22 connector.
9
If your plotter has a giant collector bar option (GCB), connect the GCB cable to CON4.
15