Gerber Technology GERBERplotter MP Series

74
GERBERplotter MP Series User Manual
English
5.3 Feeding paper and removing the paper roll
From the main window of User Manager, when adding jobs
to the print queue, you can also add the modiers CUT,
CUT PLUS, and CUT PAUSE. These indicate that when the
previous job nishes, you can remove the paper.
Now the plotter ready is ready to receive print jobs. The
following section details the process of removing the paper
from the paper take-up bar after the jobs have been printed.
There are different ways to wind the paper roll to set the
printing jobs in the correct position to allow an adequate cut.
You should cut and remove the paper roll.
PAPER
·
You can place a cut modier during the printing job. This
is done with the CUT, CUT PLUS, and CUT PAUSE
modiers, as explained in 5.3.2 Automatic advance.
·
After the last job has printed, push the PAPER button for
a few seconds. The paper advances automatically until the
last job is completely wound, so you can cut the paper.
Add cut