Gerber Technology GERBERplotter MP Series User Manual

75
GERBERplotter MP Series User Manual
English
5.3.1 Manual advance
PAPER
2
After the plotter has stopped, you can cut the paper
between the motorized bar that pulls the paper and the
paper take-up bar on which the printed jobs are wound.
To cut the paper, slide the cutter from right to left using
its handle.
3
After the paper roll has been removed and the take-up
bar replaced, push the PAPER button on the plotter
keyboard.
The paper automatically advances to be attached to the
take-up bar using the side and center clips.
4
When the paper stops, hold the paper using the side and
center clips.
PAPER
1
After the last job has printed, push the PAPER button
for a few seconds.
The paper advances automatically until the last job is
completely wound, so you can cut the paper.
This function is enabled from the main window of User Manager when adding jobs to the print queue.
You can also add the modiers CUT and CUT PLUS, which indicate when the previous job has nished and facili-
tate paper roll removal.
5.3.2 Automatic advance

Gerber Technology GERBERplotter MP Series Specifications

General

Brand	Gerber Technology
Model	GERBERplotter MP Series
Category	Plotter
Language	English